• Remove seat, pillion seat and rear seat cowling (to remove cowling you will have to disconnect key operated pillion seat release wire from catch mechanism). • IMPORTANT: IF FITTING A FULL-SIZE LICENCE PLATE AND PLACING IT FAR DOWN ON THE LICENCE PLATE HANGER, THERE IS A SMALL CHANCE OF THE LICENCE PLATE HITTING THE BACK WHEEL UNDER HEAVY LOAD AND OVER LARGE BUMPS IN THE ROAD. IT IS YOUR RESPONSIBILITY TO CHECK FOR THIS POSSIBILITY AND TAKE AVOIDING ACTION. FAILURE TO CHECK THIS COULD RESULT IN SERIOUS INJURY.

• Disconnect wiring plug located just under left side at back of rider’s seat (licence plate light).

• Undo and remove 4 bolts holding OEM licence plate bracket from underneath.

• Drop OEM licence plate bracket down carefully until licence plate light wiring loom is free.

• If not already fitted, fit new licence plate light to new licence plate bracket and secure ensuring LEDs are pointing so as to illuminate licence plate and wires are fed through 8.5mm hole in new licence plate bracket (left hand side of licence plate bracket when it is fitted) and through hole in side of cover/support.

• We suggest cutting OEM wiring plug and connecting to new licence plate light using supplied connectors.

• Offer up new licence plate bracket, as original, while feeding wires through original routing.

• Using OEM bolts secure new licence plate bracket to bike, reconnect wiring plug.

• Check light is working, secure cover/support using button headed screws supplied in kit.

• Refit rear seat cowling making sure to reconnect key operated pillion seat release wire to catch mechanism.

• Refit pillion seat.

• Refit riders seat.

• Check operation of all lights before use.

• Refit licence plate.

USUALLY DELIVERED IN 3 TO 4 WORKING DAYS OR FASTER